Introducing the NEW JPM QUAD CHOPPER!
With our Quad Chopper kits you'll be ready to convert your existing chopper assembly into a FOUR BLADE SETUP! This JPM Parts exclusive product works for both the VCM 40 and VCM 44 assemblies.
Cutter shaft is not included in these kits.
There are multiple kits available ranging from the hardware kit, upgrade kit, full upgrade kit and the complete quad assembly. For the complete quad assemblies, please view those products directly below:
Designed to work with all baffle scrapers in the VCM 40 and VCM 44.
The Quad Chopper increases your cutting efficiency in the the VCMs by a factor of two. Our kit will also provide:
- The finest mix possible
- Reduced processing times
- Reduced wear and tear with the lower mixing times
- Smooth, vibration-free operation
Our kit can be installed in two different configurations to slightly lower and raise the height of the blades. Test each configuration to see which one fits your process. All instructions are included.
Here's a breakdown on the different kits offered:
Hardware Kit [1947-HW]
6 EA: Flat Chopper Rings
1 EA: Wing Nut, Chopper Style
2 EA: Pins, Short
4 EA: Pins, Long
Upgrade Kit [1947-UK]
2 EA: Narrow Cutter Blades
6 EA: Flat Chopper Rings
1 EA: Wing Nut, Chopper Style
2 EA: Pins, Short
4 EA: Pins, Long
Full Kit Kit [1947-FK]
4 EA: Narrow Cutter Blades
6 EA: Flat Chopper Rings
1 EA: Wing Nut, Chopper Style
2 EA: Pins, Short
4 EA: Pins, Long
Important notes:
Balancing: All blades used in this assembly should be from the same brand or weigh within a few grams of each other. If you experience vibrations during operations, stop the machine and inspect the balance of the assembly.
Wing Nut: You should only use the wing nut supplied with this kit. Using any other existing nut will collide with the bowl seal and cause damage.
